Step 2
Watch tutorial videosKnown limitations
Things we are fixingFeature was just released and is therefore not jet mass tested.
Error: none / various
Solution: contact support
Fix: not needed
Changelog
Changes in our recent software updates- Bug fixed where Babystepping could affect bar printing
- Added quick command to reset heater fault
- Bug fixed where heaters would in very rare occasions throw a faulty error
- Fixed heater calibration that sometimes threw a faulty error
- Repetier Server updated to 1.4.2 (various changes and fixes)
- Temperatures can now be calibrated
- RepRap and Duet software updated to 3.4.2
- Various changes due to Duet update
- USB skripts are now possible
- Canceled prints no longer remain in the print queue
- Fixed: Error message was sometimes wrongly shown at the start of a printjob
- Warning: Default temperatures have changed slightly. This is only relevant if updating from version 1.1.2 or before directly or when resetting the defaults.
- Bug fixed where settings for the Z-Button height were not used
- nozzle size is now checked at the start of a print (new files created with choc OS required)
- bar printing is now implemented
- “go to middle” dialogue is back
- Predose dialoge redesigned
- Various other small changes and improvements
- “Predose” dialog redesigned
- New “Wizards” section (some of the former “Quick Commands” have been moved here)
- All temperatures and the nozzle diameter are now shown in the header
- Current nozzle diameter can be entered and stored
- Multiple icons added
- IP-Adress and QR-Codes have been moved from “Network” to “Info”
- Wired network settings can now be changed
- Some Quick Commands are hidden while printing
- Error fixed where “Present Z button” message was sometimes not shown or confirmation not accepted
- Custom temperatures for “Temperature” dialog can now be defined (and also reset to the defaults)
- The height of the Z button can now be changed by the user
- The “pause before unretract” time can now be changed on the printer (requires .gcodes that were
- created with a newer version of choc OS (Update will be out soon)
- User is now asked if temperatures should be changed when running out of chocolate and thus changing cartridge
- A number of copies to be printed can now be set in the print queue
- Various other small changes and improvements
- Bug fixed where printer was stuck in "present Z-button message or message did not show
- UI branded to chocolate³